- #Siemens usb ppi cable driver install#
- #Siemens usb ppi cable driver drivers#
- #Siemens usb ppi cable driver driver#
When the distance is Over 2,000m, a RS485 repeaters (model: E485GP, products of FOURSTAR as well), can be installed in the bus for extending the distance. Buy USB-MPI DP PPI for Siemens S7-200/300/400 PLC Programming Cable PC Adapter USB A2 6GK1571-0BA00-0AA0 PC Adapter For S7 System at Wish - Shopping Made. 0.22 mm2 or more unshielded twisted pair lines are used for Communications.
#Siemens usb ppi cable driver install#
And a PFB-G Bus Isolators is needed to install at the end of PLC. The largest communications range between the USB/PPI and PLC are up to 2 kilometers (9600 bps),when external plus terminals 120 ohm resistance is needed to connect between the pin3 and pin8 of the RS485 ports (DB9 Male) to eliminate signal reflection. Support a variety of high-end communication Siemens PLC. Support WIN7 32 and 64 series, support V5.5 software (no need to install the drive in V5.5). Support for multi-master communication 200PLC and ET200 communications, and PPI. Note: To communicate with the latest introduced Siemens S7-200CN CPU the following conditions must be met:ġ, Programming software version: STEP7 Micro / WIN V3.2 and above.Ģ, Set up the programming software as Chinese state. The installation of Siemens original driver, without generating serial, USB direct selection. Please note that Siemens COM port in programming software is up to support the option to COM8.But the ports more than COM8 are able to choose but in fact can not be used! This cable do not support the 187.5 Kbps baud rate as the same with the Siemens PC / PPI programming cable which with the RS232 interfaces. Quit the software and plug a USB plug or re-install the USB driver. If the COM port in the programming software with "*" symbols, such as "* COM3", it’s shown that the COM port have faults. Here are requested to indicate that "USB" option in the local communications interface setting which the software is not support to the programming cable. And the following steps are exactly the same as in the traditional programming cables with RS232 interfaces.
The step next is just to choose this COM port in the programming software and other application software and keep other communication parameters as in the Default settings.
#Siemens usb ppi cable driver driver#
And for the specific installation steps, please refer to the instruction files on the CD-ROM drivers, and details are not necessarily listed here.Īfter completing Driver installation, the corresponding COM port for the USB/PPI programming cable will be displayed in the “Device Manager” of Window.
#Siemens usb ppi cable driver drivers#
USB device drivers should be installed before using USB/MPI+ programming cable, which are available on the CD-ROM sold together with the cable.
0 kommentar(er)
